Well-prepared solutions for your projects.

Case studies

Conbit has been involved in a wide range of projects, offers specialised equipment and solutions, and can provide you with special services as described on this website. Here you will find a variety of case studies that illustrate the high quality you can expect when working with Conbit.

You can filter the list by selecting our main markets: oil & gas, wind energy, petrochemical or telecom. You can also filter by service area: lifting projects, lifting equipment or towers and stacks. An extra filter is location. You can also type in a specific search word or string.

Case Studies filtered for: Towers & Stacks

Clear filters

Guy wire tensioning for Fadhili Gas Programme

Conbit was contracted to undertake the necessary inspection and maintenance of the guy wires six per flare, and ensure that all five greenfield flares were vertical for NHS, with Saudi Aramco as the end client.

Guy wire maintenance – Oman

Conbit was contracted to perform the tensioning work to a flare stack for OXY OCCIDENTAL in Oman. The end termination of the wire ropes had to be reinstated to the prescribed minimum of seven cable claps per connection. To perform the guy wire [...]

Flare tip replacement – Australia

ExxonMobil contacted Conbit for the offshore flare tip replacement project at the Snapper (SNA) platform.

Retractable flares Thailand

Conbit expertise was requested to assist with the lowering of the riser pipes of GSP5 & GSP6, so they would be accessible for maintenance. Besides supervision, Conbit was also responsible for the procurement of lifting equipment.

Guy wire maintenance – Vietnam

Conbit was requested to assist with the maintenance of the guy wires including inspection, tension measurement, tensioning and greasing.

Latics – Telecom Tower Reinforcement

Conbit has developed Latics for reinforcement of towers: a solution for greater strength and less deflection of your telecom tower.

Structural reinforcement of high voltage pylons

Conbit offers complete engineering services for high-voltage pylon sites. We make designs and calculations for strengthening of structures and foundations, and we are one of the few companies in the Netherlands that performs full high-voltage [...]

High voltage pylon elevation

Jacking of high voltage pylons, from engineering to project execution

Conbit services retractable flares MLNG

Maintenance and modifications on a retractable flare in Malaysia at MLNG’s refinery in East Malaysia.

Bongkot Flare Tip Replacement

Flare tip replacement on the Bongkot platform together with the team of its local partner, CR Asia.

Greenfield site

Antennas and dishes are installed on the lattice tower; directly on the pile or on a secondary construction of the pile.

Rooftop site

Antennas are installed on wall mounted poles or pole frames located on the roof of a building. Sites like these need careful engineering because of the existing (weak) wall construction.

High voltage pylons

Conbit can do the complete design for antenna holders, engineer the whole Pylon or design strengthening.

Historic buildings

Sites on historic buildings should be given special attention to reduce the visibility of the telecom installation and to engineer it according special mounting specifications.

Filter skid structure

YOUR PARTNER IN LIFTING PROJECTS, LIFTING EQUIPMENT AND TOWERS/STACKS

Contact Us

We are not around right now. But you can send us an email and we will get back to you as soon as possible.

Not readable? Change text.

Start typing and press Enter to search